AnsweredAssumed Answered

The register address and value list for configuring the ADV7511 working in specific mode.

Question asked by buddha1987 on Feb 27, 2013
Latest reply on Feb 27, 2013 by buddha1987

I want to write my own C code, to configure the ADV7511 registers through IIC. I want to configured the ADV7511 working in 1080P, 4:4:4 RGB input (each component is 10bits), 4:4;4 RGB output (each component is 8 bits), and 30 fps (this should depends on video clock rate 74.25MHz)

 

In "Video Input Tables" section (4.3.2) from the ADV7511 Programming Guide,

Table 15, input ID should be 0

Table 16, 30 bits, RGB


 

I have script file "ADV7842-VER.5.9c_AVEB.txt" but there is no exact script for configuration the ADV7511 working in the mode I want. I also find the programming guide for ADV7511 has some conflicts with the script. The guide is also unclear in some points.

 

So I just wonder can I have a script, to give the exact registers address and value, I need to configure through IIC, to make the ADV7511 working in the mode I want? I already wrote the code by myself and run the design, but the display did not show anything. So I need figure out whether all the necessary registers have been configured with right value.

 

Thanks very much.

Outcomes