Is the _RESET-signal needed for using the SerialWire Interface?
Where can I can detailed information about flashing about the SerialWire interface?
Also, the document here contains the detailed reference that you would need to implement the serial wire connection yourself.
The manual UG367 has the detail information about serial interface communication. And there are examples for itftp://ftp.analog.com/pub/MicroConverter/ADuCM360V1.0/Code/examples/
is only available for registered users - any other info available?
I assume that you can just register and get it at no cost. Is that not the case?
It’s really the reference that you need if you want to bit-bang it yourself.
I haven’t looked at it myself but “CMSIS DAP” MIGHT be a collection of useful routines that might be relevant. Google it, I have it filed under something to look at if I need low level serial wire access myself. It may or may not be relevant.
I have already downloaded the docu after registration. Now I have to read and learn…
Perhaps you know: Can I use the SerialWire interface WITHOUT using the _RESET pin?
SerialWire is 2-wire J-TAG and J-TAG controls the Boundary-Scan and also the _RESET Pin?
This message has been scanned for malware by Websense. www.websense.com
You can use Serial Wire without making any use of the reset pin if that is what is needed her.
JTAG and Serial Wire are completely different interfaces.
Retrieving data ...