Please give me an advice regarding a project I'm working on. In BlackfinSDK-3.10 there is FrameCapture1 project that I try to run. The problem is that image comes from the camera distorsioned, you can see in the attached file. You can see the image following these steps:
View -> Debug Windows -> Image Viewer
Set the Start address to sFrame0
Pixel Format UYVY (4:2:2)
One more thing, it works only on debug mode. If I press build in release mode, it triggers this error:
[Warning li2060] The following input section(s) that contain program code
and/or data have not been placed into the executable for processor 'p0'
as there are no relevant commands specified in the LDF:
[Error li1060] The following symbols are referenced, but not mapped:
'_sFrame0' referenced from .\Release\FrameCapture.doj(program)
Linker finished with 1 error and 1 warning
cc3089: fatal error: Link failed
Tool failed with exit/exception code: 1.
Build was unsuccessful.
I use a Panasonic camera which uses PAL format and records at 320X240 pixels, and a Blackfin 537 proccessor.
If you need any other details, just replay and I'd be happy to give them to you.