I tried to upload a hex file to the ADuCM360 board, it gives error: received. Waiting for correct ID.
Any suggestions about this?
The device has to be placed in boot or downloader mode before it will respond to the CM3WSD program.
The entry to this mode is trigger by a certain boot mode pin being low at the time of an external reset.
On the later ADuCRF101 boards this pin is connected to a button.
If this button is not on the ADUCM360 board then you will have to manually pull this GPIO low yourself and release it after you have performed a reset.
The boot mode pin on the ADUCm360 is P2.2 so pull this low, peform an external reset and the utility will work.
Patrick, Thank you .
Retrieving data ...