I tried to simulate the AD9552 at evaluation board software, but saw a mismatch in the scheme in the data sheet and in the software.
In the DS in the figure 19 " Detailed Block Diagram " there are two output dividers (P0 = 4to11 & P1 = 1to63) and in the program three
(P0 = 4to11 & P1 = 1to63 & P2 = 1to63). There are some differences at the outputs connections. I can't specify the required output frequency or division values.
I don't have the board, I'm just choose the parts for draft project. How to use the program?