I have a new eval-adv7180 board and software CD. The CD has rev
3.56 installer on it. When I install it the GUI Configuration has a
parallel interface config on it.
There are two install guides on the disk. The install guide at
the top level is rev 3.56 and shows a USB 'light" on the GUI. The install
guide in the docs folder is rev 3.54 and shows the LPT1/2 parallel interface.
Please see the attached jpg.
I believe the ADV register control 3.56 install.exe has the
wrong version I2C interface, the MS Start link says ARC_3.56, the GUI is marked 3.56 but the
port select is for LPT1 and 2 as shown in the 3.54 Install Guide.
I have done numerous un/re-installs on 2 computers, re-read the
manual, searched the CD, and searched my emails because I believe I resolved
this once before on a since decommissioned computer.
Computer Office Windows 7 64 SP1 Pro
Computer Lab Windows XP SP3 Pro