AnsweredAssumed Answered

ADC in ADuCM360

Question asked by danielc@nexsens.com on Dec 18, 2012
Latest reply on Dec 19, 2012 by AudeR

Hi,

When I use ADC to measure the input of a thermistor, if I don't use system zero calibration and system full calibration, everything works. But when I use system zero calibration and system full calibration, it does not work. The ADC reading does not make sense. After every calibration and every single convert, I put ADC in idle mode.

 

Any ideas about this?

Thank you.

Outcomes