The Engineering Mind
Clock and Timing
Design Tools and Calculators
Direct Digital Synthesis
Embedded Vision Sensing
Energy Monitoring and Metering
FPGA Reference Designs
Interface and Isolation
Low Power RF Tranceivers
MEMS Inertial Sensors
Motor Control Hardware Platforms
Processors and DSP
RF and Microwave
Wide Band RF Transceivers
Wireless Sensor Networks
Where is this place located?
to create and rate content, and to follow, bookmark, and share content with other members.
CN0306: A 16-Bit, 100 kSPS Low Power Successive Approximation ADC System with Optimum Low Power Drive Amplifier for Sub-Nyquist Input Signals Up to 1 kHz
Discussion created by
on Dec 10, 2012
Show 0 Likes
Add your comments about the Circuit Note found at
This content has been marked as final.
(Required, will not be published)
Retrieving data ...
How to implement VHDL algorithm into PL using Linux FmComms1 design ?
Have problem with IIO-Oscilloscope plugin for AD-FMCOMMS1-ebz
IIO Oscilloscope DDS- mode for DMA
DDS Modes in IIO oscilloscope
Question for your IIO Oscilloscope