AnsweredAssumed Answered

Well functioning in émulation but not after flashing !

Question asked by Nasri.Yassin on Aug 14, 2012
Latest reply on Aug 16, 2012 by Nasri.Yassin

Hi,

 

i'm working with the ADUCRF101 MK and i developed a simple code to test the RF link depending on some conditions to toggle between RF_RX and RF_TX status. the code that i developed (here attached) functions well in the emulation mode but when i tried to flash the board using the same code and test it's response, i was surprised that it didn't work as i expected (not like emulation) !!

so, could anybody know what's wrong with it or is there any general advises to avoid such a behavior because it seems to me that it's a non-hardware related matter !

 

thanks.

Attachments

Outcomes