I got the evaluation board and its working fine, I can generate 300 kHz and 600 kHz signals.
(Single-bit serial mode (2-wire mode))
Now i wish to buy the 9959 chip alone and integrate it in my pcb, which pins are used for communication
which tools help me program the DDS?
I assume SCLK, CS BAR, SDIO_0,SDIO_3 , PINS should be connected to USB port of computer?
can this pins be connected via mini B USB terminal to computer USB port?
does the same software which is used to control/program eval board is useful now?
thanks and regards