AnsweredAssumed Answered

SSM2166 Compression ratio Selection

Question asked by rejeeshsraj on Jun 7, 2012
Latest reply on Jun 28, 2012 by rezam

We wish to use the compression ratio of 2:1 in our design. In the SSM2166 Datasheet the figure:19 tells to use 8.7KOhms for this. But in the paragraph just above tell that the values proximately 17K Ohms or less will result in 1:1 compression ratio.It is recommended to use a pot for this. In my design using a pot is difficult. Please share your comments or Graph or clarify the mis match in the datasheet so that I can approximate a value for this resistor

Attachments

Outcomes