I'm trying to connect a microcontroller (ARM) Evaluation Board in the AD9548.
I plugged in the ARM at P4 pins 4,6,8 and 10.
But for now I could not read any records.
Is there another setting I can change for the SPI work?
- Bruno Braga
Write R0x0000 with value 0x90 to enable 4-wire SPI mode (i.e. read back on the MISO/SDO line rather than the MOSI/SDIO line)
Do you works will take resistors of pull-up ?
Do you change something of Board?
Retrieving data ...