AnsweredAssumed Answered

ICE-100B pins for pcb design

Question asked by tamirci on May 8, 2012
Latest reply on May 9, 2012 by DavidS

Hi,

 

We are currently desinging a board based on Blackfin. We are going to use ICE-100B header but we can not understand which pin is pin one on referance manual and we need it due to alignment.

 

There is a mechanical drawings of ICE-100B in reference manual at page 25 - Figure 2-3. However this drawings does not indicate where is pin 1. Only J1 incidator is available but we are not sure whether it corresponds to pin 1.

 

We would like to align emulator outside of board area.

 

Any clarification?

 

Best regards,

Outcomes