AnsweredAssumed Answered

How do I program flash on my BF525 target board

Question asked by xingsing on May 1, 2012
Latest reply on May 3, 2012 by CraigG

I am new to Blackfin and VDSP.  I have a custom board using BF525 and NAND flash (K9WBG08U1M), and use HPUSB-ICE to connect to it.  I downloaded "Sample code for the ST-NAND04GW3B" I found in this forum and could compile and run it to view the NAND content.  Now I wonder if there is a tutorial on the steps required for me to program the code to the NAND so that my board can start without the ICE? My VDSP is V5.0 with update 10 applied.

 

Thanks a lot.

Outcomes