ADAU144x Multiple IC Output Routing

Discussion created by on Jan 20, 2012
Latest reply on Jan 26, 2012 by BrettG
Branched from an earlier discussion

My question is simular as it is about routing serial ports etc.  I am using Sigma Studio with 2 x ADAU1445 chips on a PCB.  I have the schematic all done but when I go to look at the Register Control for the two chips, only the information for the Routing Matrix is populated for IC1.  When I click on the IC2 tab, none of the Routing Matrix is populated.  I know the informaton must be in there somewhere because the hardware (PCB Design) works, but there is no way to change which outputs go where.


Also, is there the entire Sigma Manual in PDF form for download?


Thanks so much.