AnsweredAssumed Answered

Connector specifications for SDP1Z dev board

Question asked by BaltimoreHackerspace on Jan 26, 2012
Latest reply on Jan 30, 2012 by RRyan

I am using a SDP1z dev board in a project and I need to use both connectors from the dev board. The datasheet only shows dimensions as if you were plugging the dev board into two separate boards. I need to place both mating connectors on a single board. Can someone tell me where to find the missing dimensions?


Page 30 of this doucment gets me close but I need to be exact. There is a gap between their two example boards and the dimensions of that gap are not defined.