AnsweredAssumed Answered

Serial routing when using two Sigma ADAU1445 chips

Question asked by ben@inovon.com on Jan 22, 2012
Latest reply on Feb 8, 2012 by BrettG

My question isabout routing serial ports etc.  I am using Sigma Studio with 2 x ADAU1445 chips on a PCB.  I have the schematic all done but when I go to look at the Register Control for the two chips, only the information for the Routing Matrix is populated for IC1.  When I click on the IC2 tab, none of the Routing Matrix is populated.  I know the informaton must be in there somewhere because the hardware (PCB Design) works, but there is no way to change which outputs go where.

 

Also, is there the entire Sigma Manual in PDF form for download?

 

Thanks so much.

Ben

Outcomes