I have a question about ADV8005 TX, I set TX mode with DVI mode.
ADV8005 TX --> Sink(Monitor)
If sink already power on and ADV8005 Tx output signal, then sink can display correct DVI signal from ADV8005.
If sink is power off, and ADV8005 Tx output signal, the power on sink, sink will be no sync from ADV8005.
I didn't detect HPD from sink. And I force HPD to 1 with register setting.
I want to always output DVI signal even no connect to any sink, Is it possible?
Should I need to set "Termination Sense Monitoring Disabled" ?