I am trying to read ADXL372 data register XDATA_H to ZDATA_L i.e. register address as 0x08 to 0x0D. Instead of reading some valid values i am getting 0x00.
Below is my configuration-
All registers are 0 except
0x3D --> 0x63
0x3E --> 0x0A
0x3F --> 0x07
Below are the steps i am following to configure -
1. Reset the device
2. Configure register starting 0x3D to 0x3F
3. Confirmed registers values by reading it back from sensor.
4. delay of more than 1 sec
4. reading the data bytes from address 0x08 to 0x0D.
When i do this sensor sending 0x00 for all 6 data register.
Am I missing anything in configuration ?
Any help would be really appreciated