AnsweredAssumed Answered

GPIO Pins of ADAU1701 - Pullup resistor needed?

Question asked by Dr.Ram on Jan 10, 2012
Latest reply on Jan 15, 2012 by BrettG

Page 45 of the ADAU1701 datasheet states that "Every MP pin has an internal 15 kΩ pull-up resistor." In that case why do we need 10k resistors for these pins when used as input pins, as shown in AN-951 such as Figure 1? Can I eliminate them in my design when I know for sure they will be used only as inputs? (I have tried using them as inputs without pullups with no issues so far.)

Thanks - Ram

Outcomes