Hi every one,
My problem is how to configure the ZC706 with a static IP. My first question is about the two SD cards coming with the board with which one I must used first to do this??
Please refer section 'Instructions to Set the IPv4 Addresses' in user guide 992 for setting up ipv4 instruction.
You can start with TES GUI, one with standard size SD card and have 'uimage' file in BOOT folder.
Thanks for your replay
I follow UG992 and I boot using SD Windows based TES (This SD card include the following files : BOOT.bin, devicetree.dtb, DG1_DS_DIR_HDR, DG1_DS_VOL_HDR, uEnv.txt, uImage.) with no HDMI Output (No linux system in this case) ; You can see the error message below. The soution to remove the network cable from your windows machine and restart the GUI is not working for me
Please refer below troubleshooting guide for issues related to TES connection.
Thank you for your reply
I started from the begining to set proporely a static IP address to my ZC706 board.
for 1#item ( A. insert standard SD card shipped with the AD9371 and boot the ZYNQ board) this means I will use the SD which include zynq-zc706-adv7511-adrv9371 directory.
Use the one with 'Windows based TES/ ADRV9371-SDCARD' on it. Please refer image below and use one
selected with red rectangle.
Thank you for your help
I try to this SCcard which include these files BOOT.bin, devicetree.dtb, DG1_DS_DIR_HDR, DG1_DS_VOL_HDR, uEnv.txt, uImage. as result no HMDI output. In this case I can't finish the following steps
#ifconfig – Finds interface name; for example: eth0, eth1, etc.
#ifconfig eth0 192.168.1.10 – Set static ip address
Please let me know more about this situation
you need to setup zynq ip as 192.168.1.10 and some other staic ip to windows PC. Please refer UG992 section 'Instructions to Set the IPv4 Addresses' for details.
Latest zynq boards have already have setup this IP by default. Try pinging from windows command line to check.
You need to use ifconfig command on zynq if correct IP is not setup already.
I followed the required steps to set the IPv4 Addresses but I have always this error
I tried to boot using this SD and nothing shows in my HMDI output and so no linux operating system is launched. what I can do in this situation it seems some thing wrong with the SDcard???
Please try burning a new SD card from image available at below location.
Please also check UG992 section 'Hardware Setup' for jumpers and sw11 switches settings.
Hardware SetupThe ZYNQ platform setup (see Figure 174) requires the following steps:1. Place all jumpers in the positions shown in Figure 174.2. Place the SW11 toggle switches in the positions as shown in Figure 174 (Toggle Switch 1, Toggle Switch 2, and Toggle Switch 5 = Position A.
I download the AD9371-Image-20161130.zip and I tried to follow the following steps Windows Download and setting up the image [Analog Devices Wiki] but using Archive WinRAR ZIP it gives me a file.img and the MD5 is matched with the original one but using 7-Zip it gives me a file.img and the MD5 is not matched with the original one; Please let me kown if I missed some thing
another question please after that I will just write this file.img to the SDcard ???
Thank you so much for your help
Please use a method which result in MD5 match. Please follow instructions on below page to burn a new SD card
Retrieving data ...