AnsweredAssumed Answered

ADSP 21469 EZ Kit CLDP Process

Question asked by flying-egg on May 28, 2018
Latest reply on Jun 18, 2018 by Jithul_Janardhanan

And again I have to seek the help of this forum.

 

I'm trying to load my finished project onto the SPI parallel flash of my ADSP 21469 EZ-Kit.

I successfully created a ldr file, and am triyng now to upload it onto my device with the CLDP.

 

But when I try to upload it I get the following error message:

 

C:\Analog Devices\CrossCore Embedded Studio 2.5.0>CLDP -@ "C:\Users\Kai\cces\2.7.0\MEMI\Debug\CLDP.txt"
Target Sharc Emulators/EZ-KIT Lites
Platform ADSP-21469 EZ-KIT Lite via Debug Agent
Processor ADSP-21469
Core 0
Driver C:\Users\Kai\cces\2.7.0\MEMI\Debug\MEMI.dxe
Error: failed to resolve symbol "AFP_BreakReady".
Error: driver load failed.

 

This is the txt-File I'm using:

 

-proc ADSP-21469 -emu KIT
-driver "C:\Users\Kai\cces\2.7.0\examples\MEMI.dxe"
-cmd prog -erase all
-format hex
-offset 0
-file "C:\Users\Kai\cces\2.7.0\MEMI\Debug\MEMI.ldr"

 

I copied this from a different thread that tackled the same problem, but I'm still unable to solve my problem.

I'm pretty sure at this point that I have to select a different dxe file, but I have absolutly zero idea which one and where to get it/create it.

With VisualDSP++ programming the flash was so easy via the Flash Programmer tool. I'm a little confused about all the steps I have to take to do this with CrossCore. 

Outcomes