I want to use the GPIO3V3 pin in level translate mode. but this setting can not be found on TES's "3v3 GPIO" tab. Can not set level conversion mode in TES?
Its not possible to output TX_ENABLE_ACK on GPIO3v3 .
In level translate mode input on GPIO(low power) will get reflected on respective GPIO3v3 pin.
We will check internally and get back on this.
Just to confirm the application. Are you trying to configure GPIO to an voltage level other that 3.3V ?
I need to control an external TX/RX switch with LVCMOS 3.3 V interface, and I would like to use TX_ENABLE_ACK in ARM control mode.
TX_ENABLE_ACK can be outputed GPIO3v3?
Retrieving data ...