AnsweredAssumed Answered

Using the IMU_Evaluation software with the ADIS16448, how do I reset the factory settings? Something has gone wrong and I can no longer read anything from it.

Question asked by ebech on May 22, 2018
Latest reply on May 23, 2018 by NevadaMark

I have a new ADIS16448. I have the eval board. I loaded the USB drivers. I am running the IMU_evaluation software. I was testing how to set the calibration, when something bad happened, at which point the software would no longer read from the IMU - how do I reset this to get back in business?

 

thx

 

Eric

Outcomes