I want to generate the chirp waveform using the DRG mode, from 130 MHz to 180 MHz , step 6 KHz and step rate for example 1usec.
If you are using the evaluation board, you can check out this user guide on how to use the DRG mode of the AD9910. But if not, you can still use it as a guide on what registers are needed to be programmed for the DRG mode.
I don’t have an evaluation board ,I have an arduino uno and there is no problem in the DRG operation.
i want to generate achirp signal from 130MHz to 180MHz with 6KHz step and time rate for example 1 us
I tried to generate a register map for the chirp that you need using the evaluation software.
Retrieving data ...