AnsweredAssumed Answered

ADT7310 SPI command sending

Question asked by on Apr 27, 2018



Does SCLK must need 16 clock pulses to send 0x54, when continuous read mode setting?

Is customer procedure (below setting) correct?



My customer could not read correct temperature value.

They always read all 0 from DOUT after below setting.


Set up  "Continuous Read Mode" customer sequence 

1.Power up

2.Configuration 0x0880 by 16 sclk.

3.Command 0x54 sending by 8 SCLK.


<Status & Schedule>

They have been starting to evaluate protoype PCB.

They need to finish evaluate by top of May.

Mp is this autumn.


Best Regards