Hello everyone !!!!!!!!!!
AD9364: Is it possible to switch between tx mode or rx mode by clearing or setting the bit of register .Tx enable and filter control register(0x002) and Rx enable filter control register.(0x003).
State Machines control TDD , FDD configurations and UG-570 (User Guide) has more details. ad9361_set_en_state_machine_mode function configures the ENSM.
Please use ADI provided SW drivers for configuration of the chip.
NO_OS SW - AD9361 No-OS Software [Analog Devices Wiki]
TDD Mode Switching Time
Thanks for the quick reply Vinod..
I'm using an single port(full duplex mode) and FDD mode.....so is it possible to disable the rx path by clearing the D6 BIT of Rx enable filter control register.(0x003).
Yes the RX and TX path will get disabled and you will not see any output if bits(D7 and D6) of 0x003 and bits(D7 and D6) of 0x002 are cleared respectively.
thank you for your quick reply sir
So sir I'm clearing Tx enable and filter control register(0x002) to disable tx path but once we power on our device we are getting both rx and tx path signals.
Yes it will be there. Once you power up the device, all the initialization calibrations are done and all the settings are reset to its default state. So you need to do all the register writes again.
Yes I'm doing that only....I"m writing that register again.
Retrieving data ...