AnsweredAssumed Answered

Can Rx FMCOMMS2 receives constant value?

Question asked by mr_nazrin on Apr 5, 2018
Latest reply on Apr 6, 2018 by mhennerich

Hi Analog Team,

 

I just figure out that if I sending a sine waveform from TX1 to RX1 of fmcomms2 ( loopback configuration) , I can verify those signal correctly as shown in gnuradio Figure below.

sine wave

But I'm bit puzzled that  if my processing block send a constant value that consist of real and imaginary data, then on RX side, its seem fail to capture the those data.

constant value

 

I also verify by both cyclic mode, True and False but both gives same behaviour. My sample rate 2.084M, Manual gain 5, buffer size 10.24k. 

 

Can we rectify it?

 

Thank You

Outcomes