AnsweredAssumed Answered

Microcontroller stopped debugging. Help.

Question asked by Vinicius on Apr 4, 2018
Latest reply on Apr 5, 2018 by Vinicius


I'm working with eval-adicup3029. I created a code to read an ADC entry and control a PWM and after that enter into Hibernate mode. After doing the Debug I switched the power from the battery board to make the current consumption measurement. After that I can not debug the microcontroller. I'm using CrossCore Embedded Studio. When I send it off, it gives the following message:

Open On-Chip Debugger (Analog Devices CCES 2.6.0 OpenOCD 0.9.0-g21dc5ad) 0.9.0
Licensed under GNU GPL v2
Report bugs to <>
Info: select transport "swd"
adapter speed: 1000 kHz
cortex_m reset_config sysresetreq
Info: CMSIS-DAP: SWD Supported
Info: CMSIS-DAP: Initialised Interface (SWD)
Info: CMSIS-DAP: FW Version = 1.0
Info: SWCLK / TCK = 0 SWDIO / TMS = 1 TDI = 0 TDO = 0 nTRST = 0 nRESET = 1
Info: CMSIS-DAP: Interface ready
Info: clock speed 1000 kHz
in procedure 'init'
in procedure 'ocd_bouncer'

Can someone help me solve this problem. Thank you.