AnsweredAssumed Answered

Booting the BF-518F EZ-Board

Question asked by Wiklund on Dec 8, 2011
Latest reply on Dec 9, 2011 by Wiklund

I've spent a fair bit of time trying to get this to work, as well as searching for the information.  Basically, I can't get the EZ-Board to boot my code from internal flash.  What configurations / steps are required to do this.  My previous experience was using the SHARC DSPs, which had a very simple procedure for doing this.


General information:

I'm using the Rev. 1.0 board

I am using the codec

I am not using any external RAM