There is a problem using ADE9000 Evaluation Board.
When measuring, i always use ADE90xx EVALUATION SOFTWARE.
Until a few days ago, I was using it well.
But today, I can't connect the ADE9000 to a PC.
The following message appeared.
Communication was not establiched with the IC. Check the following:
1. Is the evaluation board powered up correctly?
2. Is the SDP board firmly attached to the evaluation board?
After verifying the above two conditions, re-run the software.
I already verified the above two conditions. But the problem is still ongoing.
I want a solution to this situation.
If possible, I want to know which device is down on the Evaluation Board.