I'm new to using the ADXL350Z Breakout Board. This board has no pins. What sort of connector can be used with this device? I would like to control and communicate to it via an NI USB-8452 I2C/SPI Interface.
Thanks for your question. It should be pretty easy to populate the standard male header(2.54mm pin header) by yourself on the breakout board.
Hope this helps.
Thank you jwang. Do you know of any special care I need to be aware of before soldering the header to the breakout board?
I don't think there's much concern when you solder the header on the eval board. You may want to check for shorts or cold joints once you finish soldering.
Retrieving data ...