I'm looking to get the status for DC loop/DC tracking. I thought this might be the DigDCOffsetMShift, but I can't see the value change as expected. Please could you advise which is the correct status to read.
Please refer UG-992 section on INITIAL CALIBRATION ERRORS. also Table 74. errorCode Designators as Included in the errorCode Parameter Returned from waitInitCals( )
The following API command is used to verify that these initial calibrations have been completed by the ARM, and it returns error information from the initialization calibrations:MYKONOS_waitInitCals(mykonosDevice_t *device, uint32_t timeoutMs, uint8_t *errorFlag, uint8_t *errorCode)where timeoutMs is the time in ms the function must wait for the calibrations to complete before returning an error, and *errorFlag and *errorCode are used to indicate if an error has occurred, and if so, which calibration returned the error.
Thanks, but I am interested in a way of determining if the calibration is still good whilst the device is operating rather than initial calibration.
MYKONOS_getDigDcOffsetEn reads channel wise digital DC offset tracking enable/disable of dc offset tracking cal. Please check if its enabled for desired channel.
Retrieving data ...