What's the difference of Hadboardsupport's dll and fifointerfacelibrary's dll ?
That is correct. I can't fully recollect why, but I think it has something to do with an inconsistency between software, firmware, and FPGA layers somewhere.
Are you getting data?
The HadBoardSupport libraries provide an abstraction layer on top of FIFOInterface library, because it supports newer hardware as well as the older hardware covered by the FIFOInterface library. Both of these libraries support communication to/from and data capture from our high-speed ADCs.
You can use either one if you're interfacing to EVALC and prior. If you're using EVALD/E, SDP-H, or ADS7 boards you should use HadBoardSupport.
Hope this helps!
I have an additional question.
When I use fifointerface library in EVALCZ board, channel B and A changed(when I put signals in channel A, I have to set to the channel B).
I don't know why it happen. Does this happen because of difference between older hardware and EVALCZ?
Yes, the data comes out normally.
Retrieving data ...