Hello, I'm a new user who uses the Blackfin.
When I run some example in ADSP-BF527 EZ-KIT Lite\Lan, I got some problem.
So long as relate to the example of LWIP, the IP ADDRESS is blank.(As the attached file.)
I didn't make any change, just build and load it on board.
I have already done switch setup according to "LAN Software Readme.txt".
Is there anything that I have to modify?
my development enviroment:
VisualDSP++ 5.0 with Update 10
ADSP-BF527 EZ-KIT LITE 1.5(C) 2007
BOM REV 1.7, Silicon Rev 0.0
Thanks a lot.