AnsweredAssumed Answered

Mechanical Drawings for the ADIS16475-3 Breakout Board

Question asked by AXP46 on Feb 9, 2018
Latest reply on Feb 9, 2018 by NevadaMark

Hi,

 

I am using the breakout board for the ADIS16475-3 and I want to do a few mechanical tests to the board. However, the mechanical information on pages 32 and 33 of the datasheet do not give all the measurements necessary for what I am trying to accomplish.

 

To be specific, I am trying to align along the point of percussion. Unfortunately, I could not determine the measurement value for where this lies on the breakout board. I do know that the point of percussion is centered on pin A1 which lies in the bottom right corner of the device when looking from above. While that is helpful, trying to determine where that is in relation to the IMU's placement on the breakout board has proven quite difficult. A more detailed mechanical drawing with measurements or an explanation of how to obtain the location of this point of percussion in reference to the entire board would be much appreciated!

Outcomes