If I need to change the TX&RX LO frequency of AD9363 to exceed 100MHz after intialization, what calibration should I re-operate.
Refer UG-1040 Table 2 for details on calibrations to be run for different conditions.
for RFDC offset and RX quad tracking cal will take care but for TX Quad you need to run cal if LO is changed more than 100 MHz.
We recommend to use ADI No-OS API, it will take care of calibrations.
Thanks a lot. Could you please give me some information about the ADI NO-OS API.
Please refer user guide Wiki which gives a good start and how to use no-OS API.
AD-FMCOMMS2-EBZ User Guide [Analog Devices Wiki]
AD9361 No-OS Setup [Analog Devices Wiki]
Retrieving data ...