In order to get the full bandwidth range (1000 Hz) of the three axes (X,Y, and Z), I will replace the capacitors C1, C2, and C3 with different ones of capacitance 0.005 μF.
Is the mentioned C value correct?
If your objective is to establish a cut-off frequency of 1000Hz, using the 32khom source impedance of each output, 0.005uF appears to be the correct value.
f = 1 / (2*pi*R*C) = 1/ (2*pi*32*1000*0.005*0.000001) = ~1000Hz
Thank you so much. Is it possible to go higher than 1000Hz, for example 1300 Hz?
I have another question regarding the "range" and the "mode" selectors on the evaluation board. For example: How can I identify physically in the range selector the VDDIO pin and the ground pin?
You are welcome! I am actually on my way out and will be out for 2 business days. I will get back to you on you bandwidth question when I return. With respect to your new question, could you please start a new discussion thread? We try to limit each thread to one question, as that makes it easier to manage the conversations, so we would appreciate it if you could start a new thread. Thank you!
Sent from my iPhone
Sure I will do that. I am a bit in hurry to have this question answered. So I will repost the question and hopefully someone could help me.
I will also repost the second question. Have safe trip!
Retrieving data ...