Hi I am targeting ADV7619 as a receiver front end. I like to know about the Dolby Atmos audio support.
Is there any special script or register setting required for that setup?
I believe that this would support Dolby atmos audio, but not sure since we have not tested this before.
Hopefully, EDID audio data block in software needs to handle this. But as per the data sheet reference, it has four I2S lines to support Dolby TrueHD, so this four I2S can receive TrueHD in ADV7619 receiver end and it will detect as High bit Rate (HBR)
Do you have one of our evaluation boards for ADV7619 like EVAL-ADV7619-7511?
How do you configure the board either through script or through software driver?
If you use our software driver to configure the board then please let us know the software driver version that you have been using it?.
If you use our scripts then please let us know which specific script that you used to configure the board which is available at ADV7619 Design Support files
Did you do the test in evaluation board to compare the results?
I have located the eval board (EVAL-ADV7619-7511). I will try to test the eval board with Blu ray player. I can extract the correct edid file from a Dolby Atmos receiver unit and will try to put in your software. I have not look at the eval software yet. Are the software and driver(and required files) available in that design support files link? After the test, I will update it here.
Please visit Advantiv™ EVAL-ADV7619-7511 Video Evaluation Board and you can see the link to download evaluation board software package here.
Retrieving data ...