i want to know if the RF port selection is performed on both receiver or transmitter at once, or is it possible to select the RF ports independently?
Thanks and kindly regards
Tx1 and Rx2 share same LO frequency and Rx1 and RX2 share same LO frequency.
Please refer 'RF port interface' section of UG-570 user guide for details on the Tx and Rx ports.
There are 3 receive ports A,B and C for both RX (1A, 1B, 1C, 2A, 2B, 2C) and 2 Tx outputs for TX1 and Tx2 ports and they can be selected as per requirement.
i was wondering because in the driver, you can only select the port (A,B,C) but not the reiver chain (1,2).
AD9361 Device Driver Customization [Analog Devices Wiki]
My question was more, if you can select different, independent, configurations (e.g. RX1A and RX2C)
Its not possible to select independent path on each channel.
Retrieving data ...