AnsweredAssumed Answered

in ADV212, when should I expect that the valid signal go active?

Question asked by AD.FAN on Nov 14, 2011
Latest reply on Nov 16, 2011 by AD.FAN

Hi,

 

After loading the encode firmware in ADV212, when should I expect that the valid signal go active? I used the ADV212 in Custom-specific and HVF mode and the data was sent to ADV212 on VDATA bus. Also I utilized Hsync, Vsync and Field signals for synchronization and I set the custom parameters in indirect registers. But no activation on valid signal was observed.

I will be grateful if someone can help me.

 

Best regards.

Outcomes