AnsweredAssumed Answered

Breakout carrier: How to use second microUSB interface to control a serial device

Question asked by LeroyKii on Nov 20, 2017
Latest reply on Nov 21, 2017 by LeroyKii

Hello,

 

(Picozed SDR 2x2 + breakout carrier)

 

I need to control one RF-modem that supports AT commands (see picture below), whose only interface is a serial port, using my PicoZed SDR 2x2.

 

Is there any way to use the second microUSB interface (highlighted in red in the picture below) using some cable adapters to control the RF-modem? If not, how else can I do this?

 

 

I don't really know where to start. I would appreciate if anybody can point me in the right direction.

 

Regards,
-Leroy

Outcomes