Post Go back to editing

LTC2983 temperature board

Hello, I am testing the LTC2983 connected to a Teensy 3.6 and the values of the temperature (RTD, PT100, 2wire) are always floating and not stable.

I need your help to define the problem. Thank you so much.



done
[edited by: WBer97 at 1:43 PM (GMT -4) on 7 Oct 2021]

Top Replies

  • Hi  ,

    Have you tried using the LTC2983 Demo software? The demo software enables you to check if your connections are valid, and it also creates a c file that you can use as a guide when programming…

Parents
  • Hi  ,

    Have you tried using the LTC2983 Demo software? The demo software enables you to check if your connections are valid, and it also creates a c file that you can use as a guide when programming your Teensy 3.6. You could also check the datasheet for the proper physical connections required by the LTC2983. I would also suggest you to read this article written by Logan Cummings as a reference when using filters in your application.

    I hope I was able to help.

    Regards, 
    Karlo

Reply
  • Hi  ,

    Have you tried using the LTC2983 Demo software? The demo software enables you to check if your connections are valid, and it also creates a c file that you can use as a guide when programming your Teensy 3.6. You could also check the datasheet for the proper physical connections required by the LTC2983. I would also suggest you to read this article written by Logan Cummings as a reference when using filters in your application.

    I hope I was able to help.

    Regards, 
    Karlo

Children
No Data