LTC2984 Thermocouple Channel Measurement

Hello,

Based on LTC2984 datasheet/user guide, I saw that a Thermocouple measurement channel natively reports the results in °C sau °F (RAM start address 0x010).

But for the same Thermocouple measurement channel (involving also Cold Junction compensation) and using custom HW design, I'm interested to directly obtain also the results in "mV", without using a Direct ADC channel.

It is possible?

In addition, for the Thermocouple extension board(DC2212A), I saw inside the Linduino One libraries(I think used also by QuikEval Demo application), that the mV results are also read from a Reserved area of RAM(start address 0x060). Can you confirm it is working and if yes, can I receive a detailed description for this reserved area?    

Regards,

Mircea