ADN4612 and ADN2915- Schematics & supported features

Hi Freddy,

The ADN4612 Evaluation board schematic can be found in the user guide, which is now available on the product page on analog.com:

http://www.analog.com/en/products/switches-multiplexers/digital-crosspoint-switches/adn4612.html#product-overview

The same holds for the ADN2915 evaluation board schematic. It can be found here:

http://www.analog.com/en/design-center/evaluation-hardware-and-software/evaluation-boards-kits/EVAL-ADN29XX.html#eb-overview

With respect to the ADN4612 questions:

The ADN4612 signal path is non-linear. It contains a limiting amplifier stage, but this is after the equalizer and is not controllable by the user.

The ADN4612 does not have an eye monitor.

The ADN4612 does not have a loopback pin, but it can route any input to any output so it will support loopback testing.

The ADN4612 is not a synchronous switch or retimer, so it does not have to adhere to jitter tolerance specifications that you are looking for.

The package xtalk data is not available but the xtalk is marginal.

The jitter spectrum is not available.

Hope this helps.

Regards,

Jarrod

is there any gui configuratpr available for adn4612 that allow to configure all registers and then export to the static table header file that can be included directly in user specific c code?

is there any gui configuratpr available for adn4612 that allow to configure all registers and then export to the static table header file that can be included directly in user specific c code?