ADG1411 isolation from input and output

Hi Kelly188 ,

Gelo,

The reason I have concerns on the leakage between S and D even when INx are set to 3.3V is that I use it as a multiple audio switch. Schematic is like the following,

If there are 60mVpp leaking on OFF channels, the output will be totally contaminated. 

Regards,

Kelly

Hi Kelly188 ,

Thank you for pointing this out. You are correct, and I apologize for the oversight. Given the age of this model, an update is a must. We will review and update the model accordingly, and I will notify you once the revised version becomes available in LTspice.

Best,

Gelo

Gelo,

Thank you for your reply. 

Can you help me to confirm whether the following circuit to use ADG1411 is good?  It basically try to use it as a 3 to 1 multiplexer.  I am debugging the circuit now. In debug,  there is a large impedance which caused the signal on the output side has unexpected attenuation. 

Regards,

Kelly

Gelo,

Thank you for your reply. 

Can you help me to confirm whether the following circuit to use ADG1411 is good?  It basically try to use it as a 3 to 1 multiplexer.  I am debugging the circuit now. In debug,  there is a large impedance which caused the signal on the output side has unexpected attenuation. 

Regards,

Kelly