max14813 EV development board unable to turned on, and whatever indication LED'S are also not turned on, we contact to your india southern regional technical team but no response from there side, please help this technically how to operate this board

Question

Issue Description and setup description:
As per max14813 EV board datasheet we followed step by step procedure and connected all voltages same. but board was turned, and indication LED'S also not turned on, but we connect board to software through usb-spi cable, Device ID: 0x20 showing, but output voltages are not coming frequencies, LV nad HV both sides low frequency, milli volts output coming and this voltage may be noise, as per your reference i attached few photos also

PeeveeS · Accepted Answer

Hi ashok989sri , Thank you for your interest in MAX14813. From your screenshot, it seems the MAX14813 was not initialized properly. For example, the error status is not updated, green is good. The "Floating Power Enable" is unchecked. The millivolt output you see is expected if the FPS is disabled. Please try to initialize the board and go through the guide once more. Here's the link for the guide, MAX14813EVKIT Evaluation Kit for the MAX14813 | Analog Devices Let me know if you are able to make the board work. Thank you. Best regards, Peevee)

Popular Forums

Product Forums

Application Forums

Design Center Forums

Highlighted Webinar

Places

Libraries

Upcoming Learning & Events

Challenge Yourself!

What's Brewing

Places

Resources

Visit ContentZone

The Latest Read

New Release

Recent Technical Insights

Products Mentioned

Thread Details

max14813 EV development board unable to turned on, and whatever indication LED'S are also not turned on, we contact to your india southern regional technical team but no response from there side, please help this technically how to operate this board