About JP1 and 2 settings of EVAL-ADGS1414D

Hi Yuya,

Apologies for this. 

Table 2 is incorrect.

Position A on both JP1 & JP2 connect to the SDP board, in line with what is displayed in Figure 9.

Kind Regards,

Karen 

Hi, Karen

Thank you for your answer.

In that case, the description in Table 1 and "When using the SDP-B controller board in conjunction with the EV-ADGS1414DSDZ, place JP1 in Position B to avoid damage to the SDP-B." is also reversed, right?

After setting the ADGS1414D switch, I would like to remove the SDP board while maintaining the switch settings.

Best regards,

Yuya

Hi Yuya,

Unfortunately, yes, this is a continuous typo throughout this user guide.

After setting the ADGS1414D switch, removing the SDP board resets the device.

Regards,

Karen 

Hi, Karen

When I checked the evaluation board, I think the mistake was in the wrong place.

Isn't A and B in Figure 9 opposite and Table 2 correct?
(Confirmed with a tester)

If I just set JP1 to Position A and supply VL externally, can I safely remove the SDP board without damaging the SDP board after setting the switch?

Best regards,

Yuya

Hi, Karen

When I checked the evaluation board, I think the mistake was in the wrong place.

Isn't A and B in Figure 9 opposite and Table 2 correct?
(Confirmed with a tester)

If I just set JP1 to Position A and supply VL externally, can I safely remove the SDP board without damaging the SDP board after setting the switch?

Best regards,

Yuya

Hi Yuya,

In the newest released versions of the board, this has been corrected and pins A & B correspond to Table 2.