Hi, does the RFC and RF1..4 ports are interchangeable?
I mean, can I use it as a Mux where I put the signal into RFC and collect it from RF1..4 ports?
Yes you can, the parts is bidirectional.Regards,
I will look into this and get you an answer asap.
Hi Rodrigo,Input at RFC will be directed to either RF 1 - RF2 -RF3 or RF4 w.r.t your selection on Pin A and Pin B.Check out Table 4 in the datasheet please.HMC241ALP3E (Rev. C) (analog.com)Best regards,
Hi yus, ok, but the HMC241AQS16 datasheet doesn't have this information. I would like to confirm if the AQS16E has the same behaviour of ALP3E.
Hi Rodrigo, Sorry about the confusion. Please find HMC241AQS16's channel selection truth table below. Regards,
Hi yus, yes, I got the datasheet.
Can I use the RFx as inputs and RFCOM as output?