I have an ADGS5414 evaluation board and note that board uses an ADG819 SPDT switch to facilitate the hardware reset of the ADGS5414.
Can I clarify one point please:-
If I decide to tie pin 20 (*RESET/VL) of the ADGS5414 permanently to VL, can I achieve the equivalent of a hardware reset by a power-on reset? Do both perform the same functions?
Pinging this again as it's holding up getting my design finished. Anyone from ADI available to assist?
Apologies for the delayed response.
If the VL pin of the ADGS5414 is tied directly to the VL power supply and the VL power supply is brought low, then this will perform a hardware reset on ADGS5414 as well.
Thanks for the clarification.